Stepper motor drivers generally receive three signals from the host controller: pulses, direction, and enable signal enable signals are also called release signals (offline signals), and most stepper motor users do not use enable signals. U...

The stepping motor generally selects the motor according to the required torque and working speed of the stepping motor. What is the relationship with the power? Thats right, power = torque * speed. In other words, we cant just look at the...

When the stepper motor driver is in a phase of power failure, the next time power on, and if this phase is different, the motor will be jitter a bit, in order to eliminate jitter, you must remember the phase of the power off. Stepper motor...

Check the cause of the abnormal operation of the stepper motor： 1、the motor torque is large enough, can drive the load, so we generally recommend the user selection to choose the actual motor torque ratio to 50%~100%, because the steppe...

一、How to control the direction of stepper motor? 1、The direction level signal of the control system can be changed. 2、You can adjust the wiring of the motor to change the direction, as follows： For two-phase machines, only one pha...

Stepper motor is a kind of induction motor, its working principle is the use of electronic circuit, the DC power supply variable components, multi-phase timing control current this current stepper motor power supply, stepper motor can work...

Stepper motor as a motor control precision displacement and large speed range special, it is the rotation of the stepping angle of the inherent angle (determined by the mechanical structure of the rotor and stator) operation step by step, w...

The motors all heat up in varying degrees, on a variety of machines, are composed of iron core and winding, winding resistance, electricity will generate losses, the magnitude of the losses is directly proportional to the square of the resi...

The stepper motor has a technical parameters: no-load starting frequency is the stepper motor to the normal start of the pulse frequency in the no-load condition, if the pulse frequency is higher than the value of the stepper motor does not...